How to use:

• Connect the SHIELD to the battery pack and the load (The load is usually a  VESC equipped with an XT60 or XT90 main power connector)

• Link the 6 pin connector between both  XLITE & XLITE-SHIELD

• Connect a momentary N.O. switch to the XLITE (the 3 pin connector)

• Turn ON the XLITE, connect over Bluetooth and configure your settings for your battery pack and also for enabling the SHIELD

  • ENNOID-BMS->Advanced->Discharge->Disabled/Enabled/Onewheel

  • ENNOID-BMS->Sleep->not used timeout->"Your preferred value" (usually between 300 to 1200 seconds with an XLITE-SHIELD so that the XLITE don't go to sleep when not being used)

From there, your XLITE controls your entire system. The XLITE-SHIELD will do the pre-discharge at init, monitor the load voltage and the discharge current. 

Note that  with the "Discharge->Enabled" option, the power output will be turned OFF if any issue is detected with your battery pack during operation.  

For critical application, use the "Discharge->Onewheel" option. After passing all safety tests and pre-discharge at init, the output will stay enabled until the power button is being long pressed or until the "not used timeout"  has passed.

The power button on the VESC is not needed anymore. Use the XLITE power button instead to turn the entire battery power ON/OFF.