Embedded Files
ENNOID-ESC-MK6-100V is a 20S capable VESC
Description:
Single motor controller
Phase shunt current sensor
100V tolerant ~20S capable (22S with limited regen.)
125A Battery, 250A Phase (XT60 battery connector limited to ~60A continuous, AWG 12 wires to ~80A continuous)
Optional Bluetooth module (mounted separate under the removable cover, using XLITE Bluetooth is also a valid alternative)
Accelerometer IMU (BMI160)
Automatic & manual shutdown (requires external N.C. momentary button, hibernation current ~30uA, long press to turn ON & OFF)
Compact and sealed aluminum case
DC Input 12 Gauge silicon wire to XT60 Male
Phase Output 12 Gauge silicon wire to 4mm Female Bullet connectors
ADC1 & ADC2 internally equipped with 10k Ohm pull-down resistors
Power outputs :
12V : 2A (JST PH limited, ~10.5V)
3.3V : 2A
5V : 2A
Enclosure dimensions: 75mm x 70mm x 18mm
Connectivity: JST-PH-2mm (CAN, SWD, UART, HALL, ADC, SERVO, 12V), USB-C
Three holes are available next to the battery connector to interface with external devices ( CAN, power switch & sensors) + 1 hole next to the motor phases for HALL. Use preferably with 3.7mm diameter Julet connector (HiGo Mini-B for ebike)
Status: Out of stock, see MK8 instead
Additionnal informations:
Power ON/OFF button: Latching type button is supported, change the setting in VESC-tool->app settings->general->shutdown mode->Always OFF
5 to 10 seconds are needed at startup for the VESC to respond to the button input
Momentary button must be removed before a firmware update otherwise, the VESC might become bricked.
Report abuse