ENNOID-ESC
ENNOID-ESC-MK8-150V is a 30S capable VESC
Description:
Single motor controller
Low side shunt current sensor
150V tolerant ~30S capable (32S with limited regen.)
75A Battery, 150A Phase (XT60 battery connector limited to ~60A continuous, AWG 12 wires to ~80A continuous)
Optional Bluetooth module (mounted separate under the removable cover, using XLITE Bluetooth is also a preferable alternative and allow PIN locking)
Accelerometer IMU (BMI160)
Automatic & manual shutdown (requires external N.C. momentary button, hibernation current ~30uA, long press to turn ON & OFF)
Compact aluminum case (possibility to make it watertight)
DC Input 12 Gauge silicon wire to XT60 Male
Phase Output 12 Gauge silicon wire to 4mm Female Bullet connectors
ADC1 and ADC2 internally equipped with 10k Ohm pulldown resistors
Aux. power outputs:
12V : 0.4A (~10V)
3.3V : 1A
5V : 0.75A
Enclosure dimensions: 58mm x 68mm x 18mm
Connectivity: JST-GH-1.25mm (CAN, SWD, 2 x UART, HALL, ADC, SERVO, 12V), USB-C
Four 4.1mm holes are available to interface with external devices ( CAN, power switch, sensors, HALL) Use preferably with 3.7mm diameter Julet connector (HiGo Mini-B for ebike)
MK8-150V shipping ETA : End of August
Additionnal informations:
Power ON/OFF button: Latching type button is supported, change the setting in VESC-tool->app settings->general->shutdown mode->Always OFF
5 to 10 seconds are needed at startup for the VESC to respond to the button input
Momentary button must be removed before a firmware update otherwise, the VESC might become bricked.