Battery Management System
ENNOID-BMS XLITE-V2 is an updated version and almost a direct drop-in replacement to the original XLITE.
UART connector for connecting either an external VESC compatible Bluetooth module or an external UART to USB adapter (Requires VESC-tool mobile app or VESC-tool desktop )
Power button connector for waking up & resetting the BMS with an external ON/OFF button switch
I2C & I/O connector for external accessories (humidity sensor, external current sensing, OLED display, expansion boards, output switches, etc)
No USB connector. VESC-tool is now the preferred method for configuring the XLITE and visualizing datas. (Via CAN bus or Bluetooth)
On-board combined Humidity+temperature sensor
Charge only, Smart BMS with VESC tool compatibility, CAN bus enabled & support external VESC Bluetooth modules
12S, 20S & 24S board options are available (20S version being almost identical to 24S version except the voltage regulator IC which is limited to 100V instead of 150V)
Charge current monitoring and discharge current tracking possible via CAN bus.
High-side charge switches, low-side charge current reading
JST PH 2.0mm balance connectors
XT30PW connectors for battery & charger connection
CAN bus on the XLITE is non-isolated. Make sure you understand the diagram provided in the "XLITE-PINOUT" file below to avoid any damage.
XLITE-24 or XLITE-20 : Please buy XLITE-24-V3 instead
2023/01, Firmware 6.00 update:
SOC tracking is now more inline with VESC
Buzzer fault reporting can now be enabled/disabled in VESC tool